Menu
Logged-In As
ACCOUNTNot Logged In
Model BRL-CAD logo in BRL-CAD (alan one)BRL-CAD
Status: ClosedTime to complete:
48 hrs
Mentors: Sean
The BRL-CAD Logo depicts two interlocked nodes. Modeling the new Logo in BRL-CAD in CSG (without NURBS, without polygons) requires some careful arrangement, but can provide an attractive three dimensional rendering that we can use for a number of purposes..
The output of this task will be a .g file of BRL-CAD logo and a rendered image. The two segments you model MUST be two or more regions hinged together (you can have center pins or not, you decide). This is your opportunity as an artist and 3D magician to come up with an interesting yet faithful interpretation.
References:
- http://brlcad.org/images/angelov_256.png
- http://brlcad.org/d/node/92
- Introduction to MGED at http://brlcad.org/wiki/Documentation
Note that there are other logo modeling tasks and yours must start from scratch and be completely original. If we get a hint that yours was based off of or used measurements from some other model, you will be barred.
This command run within MGED should help give you an interesting render:
rt -A0.75 -s1024 -c {set ambSamples=256}
I would like to work on this task.
This task has been assigned to Deep Inder Singh. You have 48 hours to complete this task, good luck!
The claim on this task has been removed, someone else can claim it now.
I would like to work on this task.
This task has been assigned to Richard Akira Heru. You have 48 hours to complete this task, good luck!
Melange has detected that the initial deadline has passed and it has set the task status to ActionNeeded. The student has 24 hours to submit the work before the task is reopened and sent back to the pool for other students to claim.
The work on this task is ready to be reviewed.
Nice work, but I would like to see some colors too.
One of the mentors has sent this task back for more work. Talk to the mentor(s) assigned to this task to satisfy the requirements needed to complete this task, submit your work again and mark the task as complete once you re-submit your work.
The work on this task is ready to be reviewed.
How about using comb_color to set them?
And shp1.c and shp3.c should be regions.
The deadline of the task has been extended with 0 days and 20 hours.
One of the mentors has sent this task back for more work. Talk to the mentor(s) assigned to this task to satisfy the requirements needed to complete this task, submit your work again and mark the task as complete once you re-submit your work.
The work on this task is ready to be reviewed.
I hope this will do.
Congratulations, this task has been completed successfully.