pix-ps — convert a color pix file to PostScript


pix-ps [-e ] [-c|-l ] [-L ] [-s input_squaresize] [-w input_width] [-n input_height] [-S inches_square] [-W inches_width] [-N inches_height] [infile.pix] >


pix-ps will take a color pix(5) format file of given dimensions and produce a Postscript file on the standard output. The -w and -n flags specify the input file width and number of scan lines in pixels. They can both be set to the same value via -s. If no input size is given, defaults of 512 are assumed.

By default the output PostScript image size is 6.75 inches. The -c option (on by default) will center it on a 8.5 x 11 inch page; otherwise, the -l option uses the lower left corner. If a different output size is desired, -S, -W, and -N can be used to set the size in inches analogous to the input parameters. Finally, -L selects landscape mode, i.e. rotates the output image by ninety degrees.

Encapsulated PostScript files can be generated via -e.


pix-ps -c image.pix >

Produces a 6.75 inch PostScript file from a 512x512 input image and centers it on an 8.5 x 11 inch page.

pix-ps -e -w 1024 -n 768 image.pix >

Takes the file image.pix which has the dimensions of 1024 pixels wide by 768 pixels high, and produces an Encapsulated Postscript version of it.

pix-ps -L -c -S 5.2 < image.pix >

Makes a PostScript file of the (assumed 512x512) image, with the output image 5.2 inches square, in landscape mode, centered on an 8.5 x 11 inch page.


brlcad(1), bw-ps(1), pix(5)




This software is Copyright (c) 1991-2016 by the United States Government as represented by U.S. Army Research Laboratory.


Reports of bugs or problems should be submitted via electronic mail to <>.