Editing MGED CMD rpp-cap
From BRL-CAD
Warning: You are not logged in. Your IP address will be publicly visible if you make any edits. If you log in or create an account, your edits will be attributed to your username, along with other benefits.
The edit can be undone.
Please check the comparison below to verify that this is what you want to do, and then save the changes below to finish undoing the edit.
| Latest revision | Your text | ||
| Line 1: | Line 1: | ||
| − | [[Category:MGED | + | [[Category:MGED]] |
| − | + | ||
=rpp-cap= | =rpp-cap= | ||
__TOC__ | __TOC__ | ||
| Line 37: | Line 37: | ||
:: Create an ARB6 shape named cap.s that extends 20 units from the 1234 face of the RPP. The peaks of the ARB6 will be at the midpoint between point 1 and 2 and at the midpoint between 3 and 4. | :: Create an ARB6 shape named cap.s that extends 20 units from the 1234 face of the RPP. The peaks of the ARB6 will be at the midpoint between point 1 and 2 and at the midpoint between 3 and 4. | ||
| − | : '''mged>''' | + | : '''mged>''' rcc-cap rcc.s cap.s 1234 20 1 |
:: Create an ARB6 shape named cap.s that extends 20 units from the 1234 face of the RPP. The peaks of the ARB6 will be at the midpoint between point 1 and 4 and at the midpoint between 2 and 3. | :: Create an ARB6 shape named cap.s that extends 20 units from the 1234 face of the RPP. The peaks of the ARB6 will be at the midpoint between point 1 and 4 and at the midpoint between 2 and 3. | ||
