Steps taken in making the chess king
1) 2 trc stalks were made using " make stalk1.s trc" and named stalks 1 and 2
2) stalk2 was inverted by selecting rotate from the GUI and then using the p 0 180 0 to 
rotate stalk2 directly above stalk1 at 180 degrees
3) A baseplate was made from a torus and named baseplate.s
4) A basefoot top wasmade from an inverted eto at 180 degrees and alligned with the baseplate 
alongside and rcc baseplatetop
5) Neck region made of a neckbase rcc  and 2 scaled down torus 
6) crown region made from an rcc base and 4 trc rotated to form a cross on the crown 
7) A chess square for the king piece was made from an arb8 and scaled down to look like a single square
8) regions were created for each section as seen bellow
 r base.r u basefoot.s u basefoottop.s u baseplate.s
 r neck.r u necbase2.s u neckbasetop2.s u necbasetop.s
 r stalk.r u stalk1.s u stalk2.s 
 r chessboard.r u chessboard.s
 r crown.r u crossarm1.s u crossarm2.s u crossarm3.s u crossarm4.s u crownbase.s
 comb chessking.c u base.r u neck.r u stalk.r u crown.r 
 comb chess.c u chessboard.r u chessking.c
 material properties applied for chess piece and board square with shaders of
 plastic and cream white and black colors
                       
Thanks
Ngwa Sedrick Meh